
MQ3 Gas Sensor is another one of MQ family of gas sensors which is used to detect the alcohol content from 0.05 mg/L to 10 mg/L. It has a sensing element made of Tin Dioxide (SnO2) which has lower conductivity in clean air but when it comes in contact with alcohol gases the conductivity increases in proportion to the concentration of alcohol present. Thus, this Alcohol Sensor module is a low cost solution to measure the alcohol level, also it is resistant to the disturbances caused by the gasoline, vapour and smoke. The sensor has Analog output corresponding to the concentration of the Alcohol gas present or you can also get Digital Output for a particular concentration using the onboard potentiometer. This module can be used as a portable alcohol detector, Gas level over limit alarm, Breathalyser etc.
Much like other Sensors in MQ Series (MQ 2, MQ 4, MQ 135 etc), this module also has 4 output pins. While connecting it to Arduino Boards, you need to power it by 5V pin and GND pin. You will get the Analog Output according to the concentration of Alcohol present and by using the potentiometer to set a threshold level of Alcohol, you can also get the digital output if the concentration goes beyond the threshold.
1 × MQ3 Alcohol Sensor Module
For official government agricultural guidelines, scheme updates, and research initiatives, please visit the National Agriculture Portal. Click here →





